Has anyone tried protocol 2 on Anan 100 hermes?

Forum rules
Until such time as the New Protocol firmware goes into general release, all discussion will be concentrated here.
User avatar
Tony EI7BMB
Posts: 175
Joined: Sun Apr 09, 2017 2:31 pm
Location: Dublin
Contact:

Has anyone tried protocol 2 on Anan 100 hermes?

Postby Tony EI7BMB » Tue Jan 08, 2019 4:38 pm

Hi guys, just wondering if anyone has tried protocol 2 firmware on the Anan 100 and if so have your encountered any show stopping issues ?
User avatar
W1AEX
Posts: 164
Joined: Sun Apr 09, 2017 6:17 pm
Location: Connecticut, USA
Contact:

Re: Has anyone tried protocol 2 on Anan 100 hermes?

Postby W1AEX » Wed Jan 16, 2019 9:56 pm

Hi Tony,

I no longer have my ANAN-100 but before I sold it back in April 2017 my Hermes ANAN-100 worked pretty well with the protocol 2 version that was out at that time. It looks like there is newer firmware now and Thetis has also evolved so you might find that it works quite well.

I had good luck with my ANAN-100 and found that I could run the gigabit firmware even with a sampling rate of 1536k without any problem with the re-settable fuse for the FPGA. I think success with the higher sampling rates will vary from rig to rig regarding the behavior of the re-settable fuse but you won't know if you don't give it a try. I see that there is a new 1000T version (v.10.5 - July 2018) and an earlier 100T version (v.10.3) posted at GitHub as well if a user wants to play with that instead.

Good luck!

Rob W1AEX
"One thing I am certain of is that there is too much certainty in the world."

Return to “Protocol 2 (all radios)”