Hi,
I am using the Anan 10 with OpenHPSDR 3.4.9
Is it possible to use the Microphone input on the front of the Anan 10 when I have the VAC1 connection enabled in the software.
I notice the Headphone socket is still active in VAC mode but the Mic input is disabled. Could I have missed a setting in the software?
I have Also posted the question to the Yahoo group
Thanks.
Bill G6SVN
Microphone input
- Tony EI7BMB
- Posts: 652
- Joined: Sun Apr 09, 2017 2:31 pm
- Location: Dublin
- Contact:
Re: Microphone input
Hi Bill, yes you can do this , take a look at the check boxes on the VAC 1 tab that start with "Allow PTT to overide/bypass VAC for phone" , you have three choices depending on how you key up TX.
Re: Microphone input
Hi Tony,
Fantastic! Its working, It was the 3rd option...Allow Mox
Was getting RF feedback through powered speakers when using primary but don't when set to VAC as audio routed through HDMI on my monitor
Thanks a million
Bill
Fantastic! Its working, It was the 3rd option...Allow Mox
Was getting RF feedback through powered speakers when using primary but don't when set to VAC as audio routed through HDMI on my monitor
Thanks a million
Bill
- Tony EI7BMB
- Posts: 652
- Joined: Sun Apr 09, 2017 2:31 pm
- Location: Dublin
- Contact:
Re: Microphone input
Happy to help Bill