All of a sudden I started getting really lousy signals on WSJT-X with my ANAN 100. Fat signals and unable to decode.
I now find there is also no audio coming out the headphones...so though that might be related.
Putting a known signal on the antenna shows clean on the scope but is far too wide on the WSJT-X display.
Any ideas? I've reset the PowerSDR database, reloaded the firmware, and still no joy.
de Mike W9MDB
No audio on headphones
No audio on headphones
Mike W9MDB
Re: No audio on headphones
Going to need more data. Maybe some screen shots.
Re: No audio on headphones
Headphones working OK....helps when you use the right plug....
Using an XG3 -73dBm 50uV signal into my TenTec Omni VII get this
Same signal into ANAN 100 looks good in the scope
But not in WSJT-X
de Mike W9MDB
Using an XG3 -73dBm 50uV signal into my TenTec Omni VII get this
Same signal into ANAN 100 looks good in the scope
But not in WSJT-X
de Mike W9MDB
Mike W9MDB
Re: No audio on headphones
You probably have a sample rate mismatch somewhere. Take a look the VAC tutorial.
Also, be sure you are using DIGU and not USB. This removes all receive audio processing automatically.
Also, be sure you are using DIGU and not USB. This removes all receive audio processing automatically.