Hi,
I just wanted to ask for confirmation of the pins for Amp Keying on the Hermes board Anan 10 (26 Pin I/O)
Looking at the schematic it shows pin 1 for PTT out and pin 2 for ground.
When converting to an IDC connector according to the Anan 200 manual this flips to pin 26 and 25 respectively.
Therefore on my breakout board I assume I should be connecting to pin 25 and 26 ?
Thanks in advance
Glenn
Anan 10 Amp Keying (Hermes I/O Pinout)
Re: Anan 10 Amp Keying (Hermes I/O Pinout)
Hello all,
any news on this?
I also would like to interface my Amplifier with the ANAN 10.
Are there any software-Buttons to activate?-Using Thetis.
Best regards
Elmar
any news on this?
I also would like to interface my Amplifier with the ANAN 10.
Are there any software-Buttons to activate?-Using Thetis.
Best regards
Elmar
Re: Anan 10 Amp Keying (Hermes I/O Pinout)
Hello all,
got all informations from here:
https://apache-labs.com/downloadsfiles/ ... -Guide.pdf
Page 54
got all informations from here:
https://apache-labs.com/downloadsfiles/ ... -Guide.pdf
Page 54