Hi,
I noted that I have LED #2 lighted in red with 7000DLE mkII firmware 2.2.2.
With firmware 2.1.8 every LED is grey.
What "LED Mirror" does it mean?
Sameone can explain briefly or send a link where can I find an explanation?
73,
Maurizio I2NOY
LED Mirror on setup F/W set window (FW 2.2.2)
Re: LED Mirror on setup F/W set window (FW 2.2.2)
Hi Maurizio,
There was some discussion of this back in April of 2022 with some speculation that it was for debugging purposes. See link below.
73, Rob W1AEX
https://community.apache-labs.com/viewtopic.php?f=9&t=4135&p=19374&hilit=LED+Mirror#p19374
There was some discussion of this back in April of 2022 with some speculation that it was for debugging purposes. See link below.
73, Rob W1AEX
https://community.apache-labs.com/viewtopic.php?f=9&t=4135&p=19374&hilit=LED+Mirror#p19374
"One thing I am certain of is that there is too much certainty in the world."
Re: LED Mirror on setup F/W set window (FW 2.2.2)
The LED Mirror is meant to be used for debugging purposes and represents
data that the firmware wants to show the user via the client app. I had enabled
LED1 and LED2 to show which Ethernet Phy chip was installed on the Orion
board. It can be either a KSZ9021 or KSZ9031.
If LED1 is lit then its a KSZ9021 else if LED2 is lit its a KSZ9031.
There is support for both in the firmware.
-Rick / N1GP
data that the firmware wants to show the user via the client app. I had enabled
LED1 and LED2 to show which Ethernet Phy chip was installed on the Orion
board. It can be either a KSZ9021 or KSZ9031.
If LED1 is lit then its a KSZ9021 else if LED2 is lit its a KSZ9031.
There is support for both in the firmware.
-Rick / N1GP
Re: LED Mirror on setup F/W set window (FW 2.2.2)
Many thanks!