Thetis opening with Panafall terminator too low

[rbduck]

I have something that has just recently started. When I open Thetis, the terminator between the Panadapter and Waterfall is located about 25% off the bottom of the GUI. I've tried what I thought was the obvious solution to the issue. I've also went back and listened to the past few of Richie's videos. What do I have to do to save to move the position upward to the middle of the GUI? I know how to move it. I just need to know how to save it.....

[ramdor]

Check that that special panafall mode is unchecked, in the spot form. It will move like that and override the position if checked and Track is ON.

special_pana.png (65.61 KiB) Viewed 718 times

[rbduck]

Check that that special panafall mode is unchecked, in the spot form. It will move like that and override the position if checked and Track is ON.

special_pana.png

That was absolutely the information I needed to correct my setup. The "Special Panafall mode" box was enabled. Thanks Richie for the fast reply and also thanks for the cmASIO video. That cleared a few things up for me as well.

[Trucker]

Thanks for posting this. I had noticed the same thing.
James
WD5GWY