I have a 7000 and would like to run QSK.
Firmware : Metis_Orion_MkII_Protocol_2_v2.0b
Software : latest Thetis beta. 2.7.0 (3/1/20)
When I try QSK it doesn't recover fast enough from TX to be considered QSK in my opinion.
In true QSK I should be able to hear signals between characters or certainly between words in CW.
I have set the filters to minimum latency. Is there anything else I can do?
Thanks
Tom AA4VV
CW QSK with the 7000
Re: CW QSK with the 7000
Thanks Helmut.
I must be doing something wrong. In QSK mode and AGC set to CUSTO as you suggested,l it takes the RX
about 1 - 2 seconds to recover from a sending of a dot.
I did cycle the AGC as you suggested.
73 Tom AA4VV
I must be doing something wrong. In QSK mode and AGC set to CUSTO as you suggested,l it takes the RX
about 1 - 2 seconds to recover from a sending of a dot.
I did cycle the AGC as you suggested.
73 Tom AA4VV
Re: CW QSK with the 7000
Helmut, It does come very close to QSK in the SEMI CW mode with a short timeer.
73 Tom AA4VV
73 Tom AA4VV
Re: CW QSK with the 7000
The original release notes for QSK operation are here:
viewtopic.php?f=9&t=3049&p=7168
Not sure that will fix your problem, but thought it might be worth posting.
viewtopic.php?f=9&t=3049&p=7168
Not sure that will fix your problem, but thought it might be worth posting.
Re: CW QSK with the 7000
Thanks Helmut and Scott.
It is working well enough. As always I appreciate the wonderful help.
73 Tom AA4VV
It is working well enough. As always I appreciate the wonderful help.
73 Tom AA4VV
Re: CW QSK with the 7000
Will the same settings work to get the Transmit / Receive switching time low for DIGU in FT8?
Thanks
Tom AA4VV
Thanks
Tom AA4VV