Page 1 of 1
Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
Posted: Sun Jul 29, 2018 11:46 am
by Dc0zo
Hello community,
after installing Thetis V 2.6.0 (beta) and FW v1.2 RX on the Anan7000 works fine but TX is not working. Panafal shows the TX Signal but Power out is 0. What is wrong? It seems to me that the Amp is not working or no RF is produced or going to the amp, The swr on the screen shows 1:1.0.
Any ideas / hints for me?
vy 73 Michael, DC0ZO
Re: Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
Posted: Sun Jul 29, 2018 1:53 pm
by w-u-2-o
The firmware is very, very alpha/beta and may not work on your radio.
You are probably doing everything correctly.
Re: Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
Posted: Tue Jul 31, 2018 2:47 pm
by DL8LAQ
Hi Michael,
no more ideas than Scott. But for me it's working nice on my 7000DLE.
73, Norbert
Re: Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
Posted: Sat Sep 15, 2018 11:32 am
by Guenter
Hello,
i have the selm Problems. No Power Output.
Here are Anan-7000, Tetis v2.60 and FW V1.2 protocol 2.
On the RX side…..Tetis is working fine.
best 73 de Guenter DK8DX
Re: Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
Posted: Sat Sep 15, 2018 3:33 pm
by kd0ldl
same here hope a firmware update happens soon, so I can use it.
Re: Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
Posted: Tue Dec 04, 2018 10:46 pm
by w-u-2-o
Helmut,
There is firmware that works. It is not publicly posted to the TAPR Github repository. When that will happen is anyone's guess. I can't get an answer out of anyone about this, either.
73,
Scott
Re: Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
Posted: Wed Jan 09, 2019 9:31 pm
by kd0ldl
it works on the 7000 now
