Hello community,
after installing Thetis V 2.6.0 (beta) and FW v1.2 RX on the Anan7000 works fine but TX is not working. Panafal shows the TX Signal but Power out is 0. What is wrong? It seems to me that the Amp is not working or no RF is produced or going to the amp, The swr on the screen shows 1:1.0.
Any ideas / hints for me?
vy 73 Michael, DC0ZO
Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
Re: Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
The firmware is very, very alpha/beta and may not work on your radio.
You are probably doing everything correctly.
You are probably doing everything correctly.
Re: Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
Hi Michael,
no more ideas than Scott. But for me it's working nice on my 7000DLE.
73, Norbert
no more ideas than Scott. But for me it's working nice on my 7000DLE.
73, Norbert
73, Norbert - DL8LAQ - ANAN-G2 w/display - Richie's latest Thetis version and pihpsdr by N1GP&DL1YCF
Re: Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
Hello,
i have the selm Problems. No Power Output.
Here are Anan-7000, Tetis v2.60 and FW V1.2 protocol 2.
On the RX side…..Tetis is working fine.
best 73 de Guenter DK8DX
i have the selm Problems. No Power Output.
Here are Anan-7000, Tetis v2.60 and FW V1.2 protocol 2.
On the RX side…..Tetis is working fine.
best 73 de Guenter DK8DX
Re: Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
same here hope a firmware update happens soon, so I can use it.
Re: Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
Helmut,
There is firmware that works. It is not publicly posted to the TAPR Github repository. When that will happen is anyone's guess. I can't get an answer out of anyone about this, either.
73,
Scott
There is firmware that works. It is not publicly posted to the TAPR Github repository. When that will happen is anyone's guess. I can't get an answer out of anyone about this, either.
73,
Scott
Re: Anan-7000 with Tetis v2.60 and FW v1.2 no TX?
it works on the 7000 now