TX EQ inop
Posted: Mon May 22, 2017 9:48 pm
My first post on the new forum. Running the latest thetis I just wanted to note the the EQ on TX does not seem to be working. I am runing a 16 bit hermes board and 1kw ldmos amp. Tx audio is a sterling audio st51 condensor mic to a behringer 202hd running VAC audio. On the air with Gordon w2gor I was being told the audio boomy and flat. I had a problem with this on the previous version of thetis but turning off vac and on again cured it. With Gordon listening and the EQ turned on I ran the eq sliders up and down while speaking with no change in audio. Tried a complete computer reboot no change. Tried making a new audio profile no change. I have not tried a mic directly to the radio only VAC 1 but it does not seem to work.
A small side note that is likely completely unrelated I do have the spots in the panadapter active. It works very well.
Ryan
KK6DZB
A small side note that is likely completely unrelated I do have the spots in the panadapter active. It works very well.
Ryan
KK6DZB