Cannot Transmit CW (SDR-Radio Console 3.0.5 and Anan 100D)
Posted: Wed Feb 27, 2019 1:32 am
Folks,
I cannot get CW transmit thru the program using an ANAN 100D. I have gone thru at the menus and Radio Configuration/CW Settings has Enable, Break-in and Iambic Mode A all chosen. In the Transmit DSP window, CW is highlighted. When I engage the paddles, I get PTT instead of CW output. I am using SDR-Radio Console 3.0.5 and an Anan 100D with Angelia Protocol 2 v11.7_7-15-18.
The transmit frequency is sync’d to the receive frequency. I know there is something I am missing but I do not know where to look. I know that there is no issue with the ANAN because using another program allows me to send CW just fine.
I have noticed one thing that my be of help. There is a Triangle on the Transmit DSP screen to the right of the TX button. It says the following: 40m ∆ PLL
Has anyone experienced this or might someone know what I might need to check at this point?
THANKS and 73, John WB4YAL
I cannot get CW transmit thru the program using an ANAN 100D. I have gone thru at the menus and Radio Configuration/CW Settings has Enable, Break-in and Iambic Mode A all chosen. In the Transmit DSP window, CW is highlighted. When I engage the paddles, I get PTT instead of CW output. I am using SDR-Radio Console 3.0.5 and an Anan 100D with Angelia Protocol 2 v11.7_7-15-18.
The transmit frequency is sync’d to the receive frequency. I know there is something I am missing but I do not know where to look. I know that there is no issue with the ANAN because using another program allows me to send CW just fine.
I have noticed one thing that my be of help. There is a Triangle on the Transmit DSP screen to the right of the TX button. It says the following: 40m ∆ PLL
Has anyone experienced this or might someone know what I might need to check at this point?
THANKS and 73, John WB4YAL