Anan 10E with no receive via ANT1, ANT2 or ANT3
Posted: Tue Dec 31, 2019 10:20 pm
Good afternoon all.
I have an Anan 10E running Hermes Ver. 1.5 firmware and OpenHPSDR mRX PS v3.4.9.
I am able to receive all bands without issue via the RX connector on the back panel. I just can't receive anything when I connect the antenna to ANT 1, ANT 2 or ANT 3.
I believe it is likely I have a box checked/not checked properly in OpenHPSDR mRX PS v3.4.9 but I can't seem to find it.
Any help would be greatly appreciated.
Thank you.
Mark
W4TGB
I have an Anan 10E running Hermes Ver. 1.5 firmware and OpenHPSDR mRX PS v3.4.9.
I am able to receive all bands without issue via the RX connector on the back panel. I just can't receive anything when I connect the antenna to ANT 1, ANT 2 or ANT 3.
I believe it is likely I have a box checked/not checked properly in OpenHPSDR mRX PS v3.4.9 but I can't seem to find it.
Any help would be greatly appreciated.
Thank you.
Mark
W4TGB