VFO B to A long delay
Posted: Thu May 17, 2018 4:06 am
Using 3.4.9 on ANAN 100
Clicking VFOB TX all is well, split is turned on, executes immediately.
But then clicking VFOA TX there is a 1.8 second delay while split is turned off, Power cycles, and VFOA is selected before a response is received via CAT control.
Why the long delay? Is there some logical reason for this?
de Mike W9MDB
Clicking VFOB TX all is well, split is turned on, executes immediately.
But then clicking VFOA TX there is a 1.8 second delay while split is turned off, Power cycles, and VFOA is selected before a response is received via CAT control.
Why the long delay? Is there some logical reason for this?
de Mike W9MDB