Anan 7000DLE microphone configuracion PowerSDR mRX
Posted: Wed Apr 04, 2018 8:10 am
Good morning
I am looking for assistance with my Anan 7000DLE.
I already finished the initial setup for the power out and also for the microphone of my Anan 7000DLE; to setup the power I did it manually by band and use dummy load to set 100W.
To setup the microphone, I followed the instructions in the manual; I am using a computer microphone (3.5mm connector with 3 parts).
However when I put the radio ready to operate, for example in 20 meters band, USB, this only puts 5-8 watts out when I speak for the microphone being the radio configured for 100w in the band that I am working.
I moved around the Transmit and General Tabs (PowerSDR), checking microphone configuration according the manual, but I can not find what I have missing about mic configuration to make the radio work properly.
Thanks in advance for any assistance or advice.
Alberto M.
DL/W4RAM
I am looking for assistance with my Anan 7000DLE.
I already finished the initial setup for the power out and also for the microphone of my Anan 7000DLE; to setup the power I did it manually by band and use dummy load to set 100W.
To setup the microphone, I followed the instructions in the manual; I am using a computer microphone (3.5mm connector with 3 parts).
However when I put the radio ready to operate, for example in 20 meters band, USB, this only puts 5-8 watts out when I speak for the microphone being the radio configured for 100w in the band that I am working.
I moved around the Transmit and General Tabs (PowerSDR), checking microphone configuration according the manual, but I can not find what I have missing about mic configuration to make the radio work properly.
Thanks in advance for any assistance or advice.
Alberto M.
DL/W4RAM