CW in the Pan and Waterfall
Posted: Mon Jan 22, 2018 12:02 am
Hi Folks
I wonder if anyone can help?
I’m talking my first tentative steps into the world of CW with my 100D. I am new to CW but familiar with the radio and software however there remains a puzzle.
When I operate on sideband it is possible to see my TX audio form flicker and move about as I speak in the panadapter and waterfall.
However in CW mode both the panadapter and waterfall show nothing (not a thing) relating to TX output. Just to be clear.... the radio goes into TX, the fwd pwr meter shows watts going out and the amp etc is receiving TX and all appears to be working fine... I’ve even gone to the trouble to to check the TX on a remote SDR... its there- it’s fine... just absolutely no visual carrier form (narrow spike) on the panadapter and waterfall?
Excuse my ignorance please, maybe I’m missing something very simple, as mentioned this is my first experience with CW mode on the Anan but I would have expected to see the visuals of a transmission on the screen?
I’ve run thru the settings tabs a couple of times but cannot find anything obvious to change and I don’t wish to mess with the settings too much.
Can anyone point or at least steer me in the right direction please
Best regards
Roly .... dit dit.
I wonder if anyone can help?
I’m talking my first tentative steps into the world of CW with my 100D. I am new to CW but familiar with the radio and software however there remains a puzzle.
When I operate on sideband it is possible to see my TX audio form flicker and move about as I speak in the panadapter and waterfall.
However in CW mode both the panadapter and waterfall show nothing (not a thing) relating to TX output. Just to be clear.... the radio goes into TX, the fwd pwr meter shows watts going out and the amp etc is receiving TX and all appears to be working fine... I’ve even gone to the trouble to to check the TX on a remote SDR... its there- it’s fine... just absolutely no visual carrier form (narrow spike) on the panadapter and waterfall?
Excuse my ignorance please, maybe I’m missing something very simple, as mentioned this is my first experience with CW mode on the Anan but I would have expected to see the visuals of a transmission on the screen?
I’ve run thru the settings tabs a couple of times but cannot find anything obvious to change and I don’t wish to mess with the settings too much.
Can anyone point or at least steer me in the right direction please
Best regards
Roly .... dit dit.