Seeing more bandwidth
Seeing more bandwidth
Hey guys, I'm very new to the Apache Labs radio but very familiar with Flex (that's what my dad had and I got quite used to it). I'm not comparing the two or at least not trying to but I do have a question. Is it possible to see more of the band you are monitoring? I can see quite a bit but on the 6300 you can see almost the entire 80 meter band. Is this possible with the Anan 100B and HPSDR? Thanks guys! Matt AJ5O
- Tony EI7BMB
- Posts: 652
- Joined: Sun Apr 09, 2017 2:31 pm
- Location: Dublin
- Contact:
Re: Seeing more bandwidth
Hi Matt, do you have "Limit Stitched receivers" unchecked under hardware config tab ?
Re: Seeing more bandwidth
What Tony said, and also in Setup > Audio > Primary you can change the sample rate to 384000 (384KHz). With that change, and using stitched receivers, you can see quite a bit.
However...if you want to use PureSignal you cannot do either. Sample rate must be 192000 or lower, and stitched receivers must be turned off.
73,
Scott
However...if you want to use PureSignal you cannot do either. Sample rate must be 192000 or lower, and stitched receivers must be turned off.
73,
Scott
Re: Seeing more bandwidth
Thanks guys, the sample rate did the trick. Apparently with the 100B you can't uncheck the stitched receivers box. Oh well. Thanks again.