Internal connections between Hermes and the 100W PA/Filter board?
Posted: Mon Mar 05, 2018 4:29 pm
Hi All
I am connecting a Hermes board from an Anan 10 to the 100W PA/filter board. I'm also using the Anan 100 case.
SMA patch cable between J5 Hermes (RX in) to J13 Amp/filter (RX out)
SMA patch cable between J3 Hermes(TX out) to J2 Amp/Filter (TX in)
SMA patch cable between J25 Hermes (10mhz in) to rear panel connector
10 pin idc cable between the 2 Alex headers
2 pin connector for speaker out from Hermes to the speaker connector on amp/filter
Have I got my connections figured out correctly?
On this Hermes board sma J1 is in place which is the low level transverter out. However there is also transverter out on the Amp/Filter board J3 derived from the tx in.
I'm guessing I can connect the rear panel transverter output to either of these?
Thanks
Stuart
I am connecting a Hermes board from an Anan 10 to the 100W PA/filter board. I'm also using the Anan 100 case.
SMA patch cable between J5 Hermes (RX in) to J13 Amp/filter (RX out)
SMA patch cable between J3 Hermes(TX out) to J2 Amp/Filter (TX in)
SMA patch cable between J25 Hermes (10mhz in) to rear panel connector
10 pin idc cable between the 2 Alex headers
2 pin connector for speaker out from Hermes to the speaker connector on amp/filter
Have I got my connections figured out correctly?
On this Hermes board sma J1 is in place which is the low level transverter out. However there is also transverter out on the Amp/Filter board J3 derived from the tx in.
I'm guessing I can connect the rear panel transverter output to either of these?
Thanks
Stuart