Transverters
Posted: Sun Aug 30, 2020 8:19 am
I have just tried to interface my Anan200D (rev24 PA) with a transverter but I am receiving HF signals and transverter signals at the same time. I have searched the internet for a solution but cannot find anything.
I am using Protocol 1 ver 5.0. with OpenHPSDR .RX ver 3.4.9. I am using Protocol 1 because Protocol 2 will not work with my radio so no option to to try Thetis. I am using ver 5.0 firmware because ver 5.1 and 5.2 break Puresignal in my radio.
In the General/Antenna setup page I have the 10m radio button set to Ant 1 (my HF antenna) and XVTR checkbox ticked. In the XVTR settings I have set up the LO Offset, start and end frequencies and have RX Only and Inhibit PA checkboxes ticked.
Selecting the VHF band correctly sets the frequency. However HF and transverter inputs are combined. Similarly when on 10m I can hear the transverter signals.
I have seen references to this problem but no fix. Any ideas before the rig goes in the recycling?
73
David
A92GE
I am using Protocol 1 ver 5.0. with OpenHPSDR .RX ver 3.4.9. I am using Protocol 1 because Protocol 2 will not work with my radio so no option to to try Thetis. I am using ver 5.0 firmware because ver 5.1 and 5.2 break Puresignal in my radio.
In the General/Antenna setup page I have the 10m radio button set to Ant 1 (my HF antenna) and XVTR checkbox ticked. In the XVTR settings I have set up the LO Offset, start and end frequencies and have RX Only and Inhibit PA checkboxes ticked.
Selecting the VHF band correctly sets the frequency. However HF and transverter inputs are combined. Similarly when on 10m I can hear the transverter signals.
I have seen references to this problem but no fix. Any ideas before the rig goes in the recycling?
73
David
A92GE