MIDI set up loaded but no controls working
Posted: Sat Aug 21, 2021 12:12 pm
My shack computer died so trying to set up new computer for control. I've a cmd studio 2A which worked perfectly with the old computer. I copied the set up from the old hard drive and loaded and saved it to the new computer. Clicking on midi setup in Thetis 9the latest version) shows the set up is there.
Once I save the file and the pop up setup box disappears I should be able to use the controller. However none of the controls are working.
I've tried:
rebooting the computer
cycling the Ana 7000lde on/ off
starting/ stopping Thetis
ending Thetis and restarting it.
None of the above have worked. Any ideas? I'd prefer, of course, not to have to create from scratch a new set up but if needed will. Not sure it will solve this as I did try a new set up file with just one wheel defined. Didn't work.
Thanks
Ron
N4XD
Once I save the file and the pop up setup box disappears I should be able to use the controller. However none of the controls are working.
I've tried:
rebooting the computer
cycling the Ana 7000lde on/ off
starting/ stopping Thetis
ending Thetis and restarting it.
None of the above have worked. Any ideas? I'd prefer, of course, not to have to create from scratch a new set up but if needed will. Not sure it will solve this as I did try a new set up file with just one wheel defined. Didn't work.
Thanks
Ron
N4XD