I have had my ANAN 7000 DLE MKII for about 3 months now and haven't upgraded or applied any patches whatsoever as, on advice from "veteran" users I wanted to stick with Protocol 1 for a while.
Is there a thread that describes how to migrate from Protocol 1 to Protocol 2 (the most "stable" and solid version)? I have been using THETIS v.2.8.11 (10/20/20) till now.
Best!
Juha
NI2M
Most "straightforward" way from P1 to P2 ?
Forum rules
Until such time as the New Protocol firmware goes into general release, all discussion will be concentrated here.
Until such time as the New Protocol firmware goes into general release, all discussion will be concentrated here.
Most "straightforward" way from P1 to P2 ?
PC: 8 Core i7-10700 CPU @ 2.90GHz, NVMe SK Hynix 512 GB SSD, 32GB RAM
Windows 10 Home, Version 22H2
Thetis v2.10.4.3 x64
Protocol 2 v2.1.18
Windows 10 Home, Version 22H2
Thetis v2.10.4.3 x64
Protocol 2 v2.1.18
Re: Most "straightforward" way from P1 to P2 ?
Not a Thetis topic, moving to the P2 sub-forum...
There is only one way from P1 to P2, and that is to load P2 firmware in your hardware and give it a whirl.
I suppose one might argue if this should be done using HPSDR Programmer or Bootloader. I'd strongly suggest Bootloader. It is a less ambiguous method, if a bit more complex.
Read the sticky posts here: viewforum.php?f=18
Then find the sticky post relevant to your hardware here: viewforum.php?f=32
and start with the latest version of firmware available.
If all else fails, go back to P1 using Bootloader.
There is only one way from P1 to P2, and that is to load P2 firmware in your hardware and give it a whirl.
I suppose one might argue if this should be done using HPSDR Programmer or Bootloader. I'd strongly suggest Bootloader. It is a less ambiguous method, if a bit more complex.
Read the sticky posts here: viewforum.php?f=18
Then find the sticky post relevant to your hardware here: viewforum.php?f=32
and start with the latest version of firmware available.
If all else fails, go back to P1 using Bootloader.
Re: Most "straightforward" way from P1 to P2 ?
Thanks Scott!
Sorry for posting this in the wrong sub-forum.
Juha
Sorry for posting this in the wrong sub-forum.
Juha
PC: 8 Core i7-10700 CPU @ 2.90GHz, NVMe SK Hynix 512 GB SSD, 32GB RAM
Windows 10 Home, Version 22H2
Thetis v2.10.4.3 x64
Protocol 2 v2.1.18
Windows 10 Home, Version 22H2
Thetis v2.10.4.3 x64
Protocol 2 v2.1.18