Hi all
I try to install Angelia_Protocol_2_v12.0 and also try Angelia_Protocol_2_v11.8 but my Anan-100d do not start up ??? why ??
if I do a IP-scanning I can't find the IP off the ANAN-100D so it looks as it do not get any IP adress ???
I use PC + ANAN-100D + Switch(go to my router) but do I need a seperat ethernet card to the ANAN-100D ???
I then flash back to Angelia_v6.0 and then it startup whit HPSDR 3.4.8 whit no problem ...
73" OZ1CT Ben
Installing Protocol-2 on my 100D FAIL!!!
Forum rules
Until such time as the New Protocol firmware goes into general release, all discussion will be concentrated here.
Until such time as the New Protocol firmware goes into general release, all discussion will be concentrated here.
Re: Installing Protocol-2 on my 100D FAIL!!!
Hi all
I have now install a new Gigabit ethernet card in to my computer and connected a cable directly to the ANAN-100D and
now my ANAN-100D startup.... so now I can start testing Thetis
73" OZ1CT Ben
I have now install a new Gigabit ethernet card in to my computer and connected a cable directly to the ANAN-100D and
now my ANAN-100D startup.... so now I can start testing Thetis
73" OZ1CT Ben
-
- Posts: 95
- Joined: Mon Apr 10, 2017 9:42 pm
- Location: Vasterasen, Bispgarden, Sweden JP82HX
- Contact:
Re: Installing Protocol-2 on my 100D FAIL!!!
Good news Ben!
Hope you find it as interesting and good as the rest of us
Hope you find it as interesting and good as the rest of us
I don’t suffer from insanity, I enjoy every second of it!
Re: Installing Protocol-2 on my 100D FAIL!!!
I saw your post earlier this morning on my phone but hate typing on that thing. I was going to ask you about your network card and switch. Now that I am at a computer I see you have solved the problem.
Yes, P2 requires Gigabit Ethernet. It will not run at any other speed. It will not auto-negotiate speeds. This is a limitation of the firmware design in order to keep it simple and small enough to fit into the smaller FPGAs.
If you buy a Gigabit Ethernet switch, you can go back to using your switch as well.
73,
Scott
Yes, P2 requires Gigabit Ethernet. It will not run at any other speed. It will not auto-negotiate speeds. This is a limitation of the firmware design in order to keep it simple and small enough to fit into the smaller FPGAs.
If you buy a Gigabit Ethernet switch, you can go back to using your switch as well.
73,
Scott