Page 1 of 1

10E Protocol2 Open collectors not working.

Posted: Mon May 11, 2020 6:06 pm
by vu3prw
I had installed the new firmware, everything works fine, but the open collector output for driving my linear amp is not working (OC Control ). no response on selection inside thetis.

I reverted it back to protocol 1 it is working well.

Kindly confirm, is this option not supported in the protocol2 firmware? or I have to
change some other settings in thetis software?

requesting help, else I have to stay with my old firmware.

Praveen, VU3PRW