apache-labs.com

Question came up in conversation, can you tell a 10 from a 10E without opening the box ?

Is it possible ?

chuck...
GM8GIQ

Hi Chuck,

I believe you can identify whether it is a 10 or a 10E by looking at the firmware version in the Hardware Config menu tab of OpenHPSDR. The ANAN-10 firmware will be in the 3.x series which is also used by the ANAN-100 rigs. The ANAN-10E firmware will be in the 1.x series which is also used by the Anan-100B rigs. This assumes that recent firmware has been loaded into the rig you are looking at.

73,

Rob W1AEX

Chuck

If you turn the 10XXX over you can tell if it is a 10E or not. A 10E has a small slide switch in the center of the bottom cover. The 10 does not.

Stu