10 or 10E

GM8GIQ
Posts: 1
Joined: Mon Mar 19, 2018 7:59 am

10 or 10E

Postby GM8GIQ » Thu Apr 26, 2018 7:36 am

Question came up in conversation, can you tell a 10 from a 10E without opening the box ?

Is it possible ?

chuck...
GM8GIQ
User avatar
W1AEX
Posts: 250
Joined: Sun Apr 09, 2017 6:17 pm
Location: Connecticut, USA
Contact:

Re: 10 or 10E

Postby W1AEX » Thu Apr 26, 2018 2:31 pm

Hi Chuck,

I believe you can identify whether it is a 10 or a 10E by looking at the firmware version in the Hardware Config menu tab of OpenHPSDR. The ANAN-10 firmware will be in the 3.x series which is also used by the ANAN-100 rigs. The ANAN-10E firmware will be in the 1.x series which is also used by the Anan-100B rigs. This assumes that recent firmware has been loaded into the rig you are looking at.

73,

Rob W1AEX
"One thing I am certain of is that there is too much certainty in the world."
AB2EZ
Posts: 94
Joined: Sun Apr 09, 2017 2:29 pm
Location: Princeton, NJ

Re: 10 or 10E

Postby AB2EZ » Thu Apr 26, 2018 2:33 pm

Chuck

If you turn the 10XXX over you can tell if it is a 10E or not. A 10E has a small slide switch in the center of the bottom cover. The 10 does not.

Stu

Return to “Hermes 14-bit (10E, 100B)”