I am observing a odd behavior looking at the network connection of my Anan 7000 DLE (blue).
The rig is loaded with the UPDATE 2.0b 10 Feb 2020 firmware and I set up a fixed IP (192.168.0.14).
Having it a fixed IP Address I expect that a ping -t 192.168.0.14 command constantly returns a valid packet answer.
On the contrary, occasionally, after some seconds, while the rig is turned on, the ping command stops receiving answers.
But if I solicitate it with some discovery packets the ping starts receiving aswer packet again. (See the attached picture)
Anyway, even if the ping command fails, I can receive still the discovery answer packet (shown below).
I am wondering if the decribed behaviour is correct or I am missing some configuration steps.
73' Enzo
iw7dmh
Code: Select all
Looking for radio using host adapter IP 192.168.0.16, port 63282
Entering Discovery() with targetIP =
Ready to receive....
====================Data len: 60
RAW Discovery data = 00-00-00-00-02-54-10-EC-9A-FB-6E-05-26-14-00-00-00-00-00-00-04-01-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
1024
Found a radio on the network. Checking whether it qualifies
Looking for radio using host adapter IP 192.168.0.16, port 63282
IP from IP Header = 192.168.0.14
MAC address from payload = 54-10-EC-9A-FB-6E
==================== Device Found ====================
IPAddress: 192.168.0.14
hostPortIPAddress: 192.168.0.16
localPort: 63282
MACAddress: 54-10-EC-9A-FB-6E
deviceType: OrionMKII
codeVersion: 20
protocol: ETH
numRxs: 4
MetisVersion: 0
PennyVersion: 0
MercuryVersion_0: 0
MercuryVersion_1: 0
MercuryVersion_2: 0
MercuryVersion_3: 0