SPE Expert 1.5k V2 issues with dual tone and PureSignal 2 (7000DLE MK2)
Posted: Fri Jun 11, 2021 8:27 am
Hi,
in my Thetis x64 latest release and protocol 2 (2.0b) setup, as soon as I send the 2 tones to linear amplifier, it is making a lot of beeps and on display it writes that I am trying to emit on a not permitted frequency and switches off power (0 W out to antenna).
I tried in 10 and 6 m and same result. I used low power setting and output from 100 to 500 W.
With single tone it is perfect; with two tones and consequent odd IMD signals, the linear amplifier always writes that I am transmitting in a wrong frequency.
I tried with and without feedback from linear amplifier
So it is impossible to use and setup PureSignal 2 with linear amplifier ON.
Any suggestion?
in my Thetis x64 latest release and protocol 2 (2.0b) setup, as soon as I send the 2 tones to linear amplifier, it is making a lot of beeps and on display it writes that I am trying to emit on a not permitted frequency and switches off power (0 W out to antenna).
I tried in 10 and 6 m and same result. I used low power setting and output from 100 to 500 W.
With single tone it is perfect; with two tones and consequent odd IMD signals, the linear amplifier always writes that I am transmitting in a wrong frequency.
I tried with and without feedback from linear amplifier
So it is impossible to use and setup PureSignal 2 with linear amplifier ON.
Any suggestion?