When do the feedback and the correcting labels get displayed?
Posted: Thu Nov 14, 2019 9:55 pm
I am working on getting Pure Signal to work with a Hermes Lite 2 board, using PowerSDRmXPS v3.4.9 with Pure Signal 2. The Hermes Lite 2 should be capable of Pure Signal. It uses the Hermes protocol and is a full duplex radio. I get the "PureSignal" to display in green but I have not been able to get any data on Amp View and there is no display of the feedback and correcting labels.
I am using a Wavenode bi-directional coupler with a Pure Signal sample port. The Hermes Lite is a 5 W radio and I am getting about -17dbm out of the sample port.
The Hermes Lite 2 community forum has been responsive, with multiple responses that "it should" work, but I can't find anyone who has actually gotten it to work. A recent change in the Hermes LIte firmware changed the Pure Signal sample receiver from 2 to 4. I get a a good spectrum display of the sampled signal when I am transmitting, but no display of the feedback or correcting labels.
Any suggestions on what I should try next?
73,
Don
K9AQ
I am using a Wavenode bi-directional coupler with a Pure Signal sample port. The Hermes Lite is a 5 W radio and I am getting about -17dbm out of the sample port.
The Hermes Lite 2 community forum has been responsive, with multiple responses that "it should" work, but I can't find anyone who has actually gotten it to work. A recent change in the Hermes LIte firmware changed the Pure Signal sample receiver from 2 to 4. I get a a good spectrum display of the sampled signal when I am transmitting, but no display of the feedback or correcting labels.
Any suggestions on what I should try next?
73,
Don
K9AQ