Page 1 of 1
Upgrading PS from 1 to 2....
Posted: Sun Apr 30, 2017 4:46 pm
by Bill in Georgia
Just installed 3.3.15, in my 200D, and I see there have been changes in Pure Signal, read WA!OXT's epistle on Pure Signal 2.0 ... and before I get to far down the road, am wondering if the mechanical lash-up is the same as #1... in other words use of the coupler/Dummy Load/Pad. etc.
Thanks
Bill - KC4PE
Re: Upgrading PS from 1 to 2....
Posted: Sun Apr 30, 2017 9:03 pm
by w-u-2-o
Yes, the feedback paths, methods and levels all remain the same.
73,
Scott
Re: Upgrading PS from 1 to 2....
Posted: Mon May 01, 2017 12:51 am
by Bill in Georgia
Thanks..
Re: Upgrading PS from 1 to 2....
Posted: Thu May 11, 2017 11:23 pm
by N9VX
Where do I find this document? " read WA!OXT's epistle on Pure Signal 2.0 " I am trying to setup PureSignal 2.0 with internal crosstalk and see how it works, and then graduate to external coupler.
Joe N9VX
Re: Upgrading PS from 1 to 2....
Posted: Fri May 12, 2017 1:29 am
by w-u-2-o
N9VX wrote:Where do I find this document? " read WA!OXT's epistle on Pure Signal 2.0 " I am trying to setup PureSignal 2.0 with internal crosstalk and see how it works, and then graduate to external coupler.
Joe N9VX
Not sure what that is, but I just posted the PureSignal 2.0 release notes in this subforum:
https://apache-labs.com/community/viewtopic.php?f=20&t=2409