HPSDRProgrammer V2.0 puzzle (200D)
Posted: Mon Aug 06, 2018 7:44 pm
My 200D Protocol 1 firmware is old, (4.3) so I checked and saw that both 5.0 and 5.2 were on GitHub.
This Windows 10 PC is relatively new and didn't have WinPCAP installed, so I did that part then installed and ran HDPSDRProgrammer V2.0 .
Discovery is pretty much instant - the 200D consistently gets an address from my router, and the correct address showed up in the Discovery field. (MikroTik core router, radio is one L2 switch hop away)
I clicked the Browse button to point to the new .rbf file, and get the following:
The error message isn't correct, obviously. What I don't know is what it actually means.
Has anyone seen this before?
Thanks,
Jim N7CXI
This Windows 10 PC is relatively new and didn't have WinPCAP installed, so I did that part then installed and ran HDPSDRProgrammer V2.0 .
Discovery is pretty much instant - the 200D consistently gets an address from my router, and the correct address showed up in the Discovery field. (MikroTik core router, radio is one L2 switch hop away)
I clicked the Browse button to point to the new .rbf file, and get the following:
The error message isn't correct, obviously. What I don't know is what it actually means.
Has anyone seen this before?
Thanks,
Jim N7CXI