7000DLE Tandem RCA Jack Mounting
Posted: Sat Apr 20, 2019 1:17 pm
The attached photo shows a set of #4 tapping screws added to hold the tandem RCA jacks in place on the back panel. Installation was very easy. A set of plastic mounting holes pass completely through. So, once the back panel is off, it’s simply a matter of drilling through the mounting holes from the back side. In a couple minutes the job was done. No measuring required.
Although I used tapping screws, one could use machine screws. Then, add a #4 lock washer and nut to hold the jack captive against the panel.
Paul, W9AC
Although I used tapping screws, one could use machine screws. Then, add a #4 lock washer and nut to hold the jack captive against the panel.
Paul, W9AC