RS232 INTERFACE/ CIRRO MAZZONI BABY LOOP
Posted: Thu Aug 23, 2018 11:46 am
Good Morning All,
I have a Cirro Mazzoni Baby loop, http://www.ciromazzoni.com/loop-baby, antenna which works fine with the ANAN 100D from 7.0 - 28.0 mHZ. As with any other mag loop, it has a narrow tuning range per each frequency and has to be retuned when moving a few kHZ up or down the band. This tuning is done by entering the frequency number on a touch pad that is connected to an ATU unit. There is a hands free upgrade to this procedure with the purchase of a RS232 kit, from the manufacturer, https://www.youtube.com/watch?v=NihyFuHq3ng&t=30s which will sense the frequency from the rig and tune the antenna. Can the ANAN 100D somehow accomodate this hardware through the accessory port?
Thanks for any help you can offer.
Mark
WA2DIY
I have a Cirro Mazzoni Baby loop, http://www.ciromazzoni.com/loop-baby, antenna which works fine with the ANAN 100D from 7.0 - 28.0 mHZ. As with any other mag loop, it has a narrow tuning range per each frequency and has to be retuned when moving a few kHZ up or down the band. This tuning is done by entering the frequency number on a touch pad that is connected to an ATU unit. There is a hands free upgrade to this procedure with the purchase of a RS232 kit, from the manufacturer, https://www.youtube.com/watch?v=NihyFuHq3ng&t=30s which will sense the frequency from the rig and tune the antenna. Can the ANAN 100D somehow accomodate this hardware through the accessory port?
Thanks for any help you can offer.
Mark
WA2DIY