Re: Angelia F3 PTC ("fuse") replacement/upgrade for Protocol 2
Posted: Sat Feb 26, 2022 1:10 pm
Hi,
Following this topic with the lid being off my 100D
Is there any evidence to suggest the new fuse or bridge enables the 100D to run P2 more reliably. Also curious if anyone did the cooling mod(uprated fan) + this mod together actually found more or less stability.
OT but the pressed riser ~~~~ filter under the fan looks directional to the sides of the case. I was thinking about turning it 90deg toward the PSU and the F3 fuse in a bid to pull heat from the lower deck....
TIA
Following this topic with the lid being off my 100D
Is there any evidence to suggest the new fuse or bridge enables the 100D to run P2 more reliably. Also curious if anyone did the cooling mod(uprated fan) + this mod together actually found more or less stability.
OT but the pressed riser ~~~~ filter under the fan looks directional to the sides of the case. I was thinking about turning it 90deg toward the PSU and the F3 fuse in a bid to pull heat from the lower deck....
TIA