TX Inhibit Function
Posted: Fri Dec 01, 2017 3:29 pm
First, I want to say thank you for all of the great information here. I just wanted to confirm the setup of the TX Inhibit function on my 8000. If I understand correctly I will use the digital input #1 (RCA connector) and select the checkbox in setup to enable. I use Wavenode WN-2 for SWR protection, the RCA center pin to ground which will Inhibit transmit if SWR is above set limit. Will this Inhibit all transmit modes and functions - cw key, foot switch, tune, mox, keyboard?
Thanks and 73’s
Joe
WD5Y
Thanks and 73’s
Joe
WD5Y