ADC 2 not working?
Posted: Mon Jul 10, 2017 4:22 pm
I have an Anan 200D, I have been enjoying the radio for over 3 years. I finally got around to installing a Butternut HF9V to use as a second antenna for diversity operations. I connected the HF9V to the Ant2 BNC at the rear of the radio. I double checked that the ADC2 was setup to use Ant2, all was well.
At least I thought that was the case. I am getting no/zero signal indication from the ADC2/Ant2 setup.
The ADC1 seems to work well connected to the Ant2. My question is, have I inadvertently screwed up my settings or do I have a bad ADC2. Sorry for the dumb question.
Using both antennas with ADC1 the diversity seems to work very well. MultiRX is fantastic also. Do I really need the second ADC?
At least I thought that was the case. I am getting no/zero signal indication from the ADC2/Ant2 setup.
The ADC1 seems to work well connected to the Ant2. My question is, have I inadvertently screwed up my settings or do I have a bad ADC2. Sorry for the dumb question.
Using both antennas with ADC1 the diversity seems to work very well. MultiRX is fantastic also. Do I really need the second ADC?