WSJT-x and ANAN10E
Posted: Sun Jul 08, 2018 1:07 pm
Good Morning All,
I know this can be a rabbit hole when talking about two software systems playing nicely. But, on the chance that someone may have the same issue, I will explain. I use WSJT-x, (v 1.9) both with my ANAN 100D and ANAN 10E. The 100D performance is nominal and there are no issues. However, the 10E's problem is that everytime I go to TX, the mode, on the transcvr, switches from DIG to USB. Also, the VAC is turned off, as well, at the same moment which, of course, cuts off my outgoing signal. I have tried using v1.8 but no change in the problem. I have tried rebuilding the database of OPENHPSdr v3.4.9 also with no success. I do not have this issue with FLDIGI or other third party software applications with the 10E.
Anyone experience something like this? Have I gone through all the troubleshooting steps to correct this?
73
Mark
WA2DIY
I know this can be a rabbit hole when talking about two software systems playing nicely. But, on the chance that someone may have the same issue, I will explain. I use WSJT-x, (v 1.9) both with my ANAN 100D and ANAN 10E. The 100D performance is nominal and there are no issues. However, the 10E's problem is that everytime I go to TX, the mode, on the transcvr, switches from DIG to USB. Also, the VAC is turned off, as well, at the same moment which, of course, cuts off my outgoing signal. I have tried using v1.8 but no change in the problem. I have tried rebuilding the database of OPENHPSdr v3.4.9 also with no success. I do not have this issue with FLDIGI or other third party software applications with the 10E.
Anyone experience something like this? Have I gone through all the troubleshooting steps to correct this?
73
Mark
WA2DIY