HPSDR locking on as N1MM+ starts
Posted: Tue Jun 06, 2017 12:37 pm
I guess I have a setup problem, but after many hours I have not been able to sort it.
The problem is as follows:-
1. Run HPSDR (v3.4.1 but occured on earlier versions as well) then start N1MM+ (latest version) part way through starting it will lock the PTT line ON
2. Going into N1MM+ Config>Config Ports..then OK will release the PTT.
3. If I untick the ENABLE CAT Box in HPSDR SetUp>CAT Control>CAT will also prevent the lock up as N1MM+ starts.
4. I have gone back through the releases of N1MM+ and find that the problem started after version 1.0.5327
I am running Win 10 but get the same effect with Win7. vspMgr provides the COM ports (had trouble getting this to work on W10)
VB provides the Audio Cables.
TIA
Geoff G3NPI
The problem is as follows:-
1. Run HPSDR (v3.4.1 but occured on earlier versions as well) then start N1MM+ (latest version) part way through starting it will lock the PTT line ON
2. Going into N1MM+ Config>Config Ports..then OK will release the PTT.
3. If I untick the ENABLE CAT Box in HPSDR SetUp>CAT Control>CAT will also prevent the lock up as N1MM+ starts.
4. I have gone back through the releases of N1MM+ and find that the problem started after version 1.0.5327
I am running Win 10 but get the same effect with Win7. vspMgr provides the COM ports (had trouble getting this to work on W10)
VB provides the Audio Cables.
TIA
Geoff G3NPI