ANAN 7000 DLE connecting to ACOM 2000A via DDUTIL
Posted: Mon Mar 30, 2020 6:03 pm
Hello experts of DDUTIL configuration,
I have been running my 7000 DLE together with my 2000A via CAT+ using Thetis or (formerly) 3.4.9 mRX for a long time.
Now I am experimenting with DDUTIL (Version 3.2.5).
- what are the real settings on ACOM side and in DDUTIL? I cannot configure 1200 Baud in the ACOM setup as described in DDUTIL help....
- I am using a Microham interface providing 2 virtual ports (Eltima). In DDUTIL it seems that I am not able to set any dedicated Baud rate for HPSDR communication. Looking at my Microham URouter diagnostics it seems that DDUTIL is trying to establish a communication with 9600 8 N1. When I set my port to 9600 8N1 I see that there is TX/RX traffic. But DDUTIL does not connect...
any helping comments/ hints will be highly appreciated
TNX and stay healthy
Volker
DL4ZBG/DK0B
I have been running my 7000 DLE together with my 2000A via CAT+ using Thetis or (formerly) 3.4.9 mRX for a long time.
Now I am experimenting with DDUTIL (Version 3.2.5).
- what are the real settings on ACOM side and in DDUTIL? I cannot configure 1200 Baud in the ACOM setup as described in DDUTIL help....
- I am using a Microham interface providing 2 virtual ports (Eltima). In DDUTIL it seems that I am not able to set any dedicated Baud rate for HPSDR communication. Looking at my Microham URouter diagnostics it seems that DDUTIL is trying to establish a communication with 9600 8 N1. When I set my port to 9600 8N1 I see that there is TX/RX traffic. But DDUTIL does not connect...
any helping comments/ hints will be highly appreciated
TNX and stay healthy
Volker
DL4ZBG/DK0B