apache-labs.com

Posted: **Mon Dec 02, 2019 10:25 am**

Hi,

I just wanted to ask for confirmation of the pins for Amp Keying on the Hermes board Anan 10 (26 Pin I/O)

Looking at the schematic it shows pin 1 for PTT out and pin 2 for ground.

When converting to an IDC connector according to the Anan 200 manual this flips to pin 26 and 25 respectively.

Therefore on my breakout board I assume I should be connecting to pin 25 and 26 ?

Thanks in advance

Glenn

Posted: **Wed Feb 12, 2020 8:40 am**

Hello all,
any news on this?
I also would like to interface my Amplifier with the ANAN 10.
Are there any software-Buttons to activate?-Using Thetis.
Best regards
Elmar

Posted: **Thu Feb 13, 2020 5:18 am**

Hello all,
got all informations from here:

https://apache-labs.com/downloadsfiles/ ... -Guide.pdf
Page 54
:geek:

apache-labs.com

Anan 10 Amp Keying (Hermes I/O Pinout)

Anan 10 Amp Keying (Hermes I/O Pinout)

Re: Anan 10 Amp Keying (Hermes I/O Pinout)

Re: Anan 10 Amp Keying (Hermes I/O Pinout)