I have seen some arduino libraries for FlexRadio.
I’m looking for a simple Arduino sketch that interpret the “ZZFA” and “ZZFB” result strings to make a band decoder for my homebrew amplifier (input filter).
My future TX is the Anan8000 with PowerSDR and I don’t want to use de TTL signals on the J16 port but the serial data on the PoweSDR cat serial port.
Do you know where I can find this code ?
Bests 73s
Eric – F1FLY
Arduino sketch for PowerSDR cat
Re: Arduino sketch for PowerSDR cat
Bonjour
Avez vous résolu votre probléme de CAT
entre ANAN 8000 et ARDUINO
73's Pierre F5AFV
f5afv-p@wanadoo.fr
Avez vous résolu votre probléme de CAT
entre ANAN 8000 et ARDUINO
73's Pierre F5AFV
f5afv-p@wanadoo.fr
Re: Arduino sketch for PowerSDR cat
Hi Alex,
read better the Alexbus, the Orion MK2 board outputs 48bit, LPF, BPF1, BPF2, you read the last 16bit, that is the information for antenna / lpf including TX Signal.
regards René
read better the Alexbus, the Orion MK2 board outputs 48bit, LPF, BPF1, BPF2, you read the last 16bit, that is the information for antenna / lpf including TX Signal.
regards René