Re: Voicemeeter Potato (VMP) is here!
Posted: Thu Apr 23, 2020 5:49 pm
What are the vac 1 settings when using Voicemeeter Potato?
John N2xd
John N2xd
More typically you would do this: put PowerSDR VAC1 on VMP virtual channel 1, VAC2 on virtual channel 2, digi software on virtual channel 3, and an ASIO interface (like the Focusrite) on hardware input 1 and hardware output 2. Then mix/route as desired.
The "proper" way to do this is as follows:Mic (Focusrite ASIO *) => DAW-App => openHPSDR VAC1
w-u-2-o wrote:Ken,
Your post isn't making sense to me. WSJT-X does not support ASIO. Therefore it cannot "see" any ASIO drivers.
I just checked and they are selectable options in WSJT... since the radio did not 'see' them, I can not verify if they actually work.
Are you saying that when you select ASIO as the driver in Thetis there are no devices available to assign?
Yes, just double checked after I made the assignments in WSJT.
Finally, and I'm not sure this is relevant, but when you install any new software from VB Audio you must uninstall the old VB Audio software, reboot, install, and reboot. This is right in all of the VB Audio user guides.
This might be the key... I checked and did not find the ASIO selections in VMP. I had MME, WDM, and KS options available, but no ASIO.
Thanks for your reply
73,
Scott
I just checked and they are selectable options in WSJT... since the radio did not 'see' them, I can not verify if they actually work.
This might be the key... I checked and did not find the ASIO selections in VMP. I had MME, WDM, and KS options available, but no ASIO.