VMB Virtual Cables: cross connect or not?
Posted: Sun Apr 29, 2018 4:09 pm
Scott
et al.
When I use the VMB virtual cables for VAC1, I have used them as recommended by Scott:
E.g. VAC1 output from transceiver => VMB virtual channel input. VMB virtual channel => B2 (aux virtual channel output) . WSJT input => Aux VMB virtual channel output
But, everything seems to work fine if (alternatively) I use the virtual cables on a straight through basis
E.g. VAC1 output from transceiver => VMB virtual channel input. VMB virtual channel => B1 (virtual channel output) . WSJT input => VMB virtual channel output
Is there really an advantage of using the cross connected arrangement over the straight through arrangement?
Stu
et al.
When I use the VMB virtual cables for VAC1, I have used them as recommended by Scott:
E.g. VAC1 output from transceiver => VMB virtual channel input. VMB virtual channel => B2 (aux virtual channel output) . WSJT input => Aux VMB virtual channel output
But, everything seems to work fine if (alternatively) I use the virtual cables on a straight through basis
E.g. VAC1 output from transceiver => VMB virtual channel input. VMB virtual channel => B1 (virtual channel output) . WSJT input => VMB virtual channel output
Is there really an advantage of using the cross connected arrangement over the straight through arrangement?
Stu