Page 1 of 1

VAC Tutorial

Posted: Sun Dec 10, 2017 12:28 pm
by w-u-2-o

Re: VAC Tutorial

Posted: Sat Nov 10, 2018 4:59 am
by Dick
Hi Scott

Your tutorial discusses ===>
"2.0 This document is divided into the following parts.

A review of the functional basics, rules and software limitations associated with the PowerSDR virtual audio interface.
Suggestions for testing and tuning system performance for real-time audio.
How to quickly setup a USB headset for use with PowerSDR.
Virtual PTT switching for virtual audio.
Latency: what it is and how to minimize it.
How to setup up Voicemeeter Banana and interface digital mode software audio streams.
Virtualizing CW operations.
Integrating Digital Audio Workstation (DAW) software.

but I do not see anything about how one can plug a microphone into the computer running PowerSDR and
pipe the audio to a remote ANAN-200D/7000dle/etc using VAC1.

Is this possible ? My radio room in the shop gets down in the low 30's quite often in Winter and operating there gets
pretty uncomfortable!

Re: VAC Tutorial

Posted: Sat Nov 10, 2018 12:31 pm
by w-u-2-o

Yes, using VMB to route microphone and receiver audio was not covered in the tutorial, which is pretty basic. My radios live in a rack in the basement and I operate exclusively from my second floor studio office, i.e. I do exactly what you are seeking to. I will address your questions in your other thread--look there soon.



Re: VAC Tutorial

Posted: Sat Nov 10, 2018 4:16 pm
by Dick
GM Scott

Many thanks for addressing this topic. It seems like every time I try something related to software applications changes
it ends up being a "tar-baby" where the problem just gets worse! Then I spend days getting something that worked
fine back in operation.

RF and circuit design is a comfortable arena for me but this computer stuff seems like fighting in a Vietnam jungle

I will look at what your next posting provides. Again many thanks for your SW-knowledge and dedication to growing
the SDR spirit in our Ham community.

73 Dick/w7wkr