How to set up VAC2 with VMB and the UMC202HD
Posted: Thu Nov 23, 2017 6:01 pm
Scott,
I have looked through the site and don't seem to be able to find anything specifically relating to the setup of VAC2 with VMB and the UMC202HD. I would like to get this operating as I switched to using all digital audio after installing the UMC202HD per your suggestion and have no problems as long as I don't try to use RX2. If I want to use it, I have to go back to internal Anan audio by plugging the headphones into the headphone jack on the radio. I also use this method on CW to get sidetone. I know there is a kludge to make this work but it is easier to just plug the headphones into the radio for CW.
In trying to get VAC2 to work along with VAC1, I discovered it isn't possible to use the ASIO driver for both. I can get VAC2 to work if I set it up exactly as VAC1 and turn VAC1 OFF but can't run both simultaneously.
I assume I need to use a different driver for VAC2; perhaps MME or something else so this is my question. What is the preferred way to get VAC1 and VAC2 operating together with the UMC202HD and VMB (assuming it is possible)?
Thanks,
Joe W4WT
I have looked through the site and don't seem to be able to find anything specifically relating to the setup of VAC2 with VMB and the UMC202HD. I would like to get this operating as I switched to using all digital audio after installing the UMC202HD per your suggestion and have no problems as long as I don't try to use RX2. If I want to use it, I have to go back to internal Anan audio by plugging the headphones into the headphone jack on the radio. I also use this method on CW to get sidetone. I know there is a kludge to make this work but it is easier to just plug the headphones into the radio for CW.
In trying to get VAC2 to work along with VAC1, I discovered it isn't possible to use the ASIO driver for both. I can get VAC2 to work if I set it up exactly as VAC1 and turn VAC1 OFF but can't run both simultaneously.
I assume I need to use a different driver for VAC2; perhaps MME or something else so this is my question. What is the preferred way to get VAC1 and VAC2 operating together with the UMC202HD and VMB (assuming it is possible)?
Thanks,
Joe W4WT