Connections
Posted: Tue Jun 20, 2017 4:10 pm
On the 8000DLE:
Some connections on photo of front and rear panel seem a little confusing or more than one can be used. Who like info on proper or optimal
connects.
(1) where can a foot switch be plugged in? I see a PTT IN and a PTT OUT?
(2) Already have Bose Companion II speakers. Would the Stereo Headphone jack on rear work for these speakers?
(3) I also have a pair of non powered speakers and see a R SPK and a L SPK. Can these non powered speakers be plugged into these connections??
Assume wired tip and sleeve each or one tip and sleeve and the other tip and ring????????
(4) I have a computer type Yamaha and Logitech Headset that uses the tip, ring and sleeve 3.5mm stereo connector for mic so assume they
will work with no modifications although we are not fond of headsets??????
(5) I have several dynamics here, EV, Heils etc. Understand power to the mic connection can be turned off so no blocking cap should be needed.
Very basically would I just wire the + Mic wire to TIP and the -Mic wire(shield) to sleeve......... on a 3 connector stereo phono plug??
Thanks de KE4WY Jim
Some connections on photo of front and rear panel seem a little confusing or more than one can be used. Who like info on proper or optimal
connects.
(1) where can a foot switch be plugged in? I see a PTT IN and a PTT OUT?
(2) Already have Bose Companion II speakers. Would the Stereo Headphone jack on rear work for these speakers?
(3) I also have a pair of non powered speakers and see a R SPK and a L SPK. Can these non powered speakers be plugged into these connections??
Assume wired tip and sleeve each or one tip and sleeve and the other tip and ring????????
(4) I have a computer type Yamaha and Logitech Headset that uses the tip, ring and sleeve 3.5mm stereo connector for mic so assume they
will work with no modifications although we are not fond of headsets??????
(5) I have several dynamics here, EV, Heils etc. Understand power to the mic connection can be turned off so no blocking cap should be needed.
Very basically would I just wire the + Mic wire to TIP and the -Mic wire(shield) to sleeve......... on a 3 connector stereo phono plug??
Thanks de KE4WY Jim