Search found 6 matches

by wv5k
Thu Mar 22, 2018 11:48 pm
Forum: Protocol 2 (all radios)
Topic: "New Protocol" explained...
Replies: 2
Views: 4347

Re: "New Protocol" explained...

"Until such time as the New Protocol firmware goes into general release, all discussion will be concentrated here." Nothing new posted in months. WU2O has implied elsewhere there may have been some positive developments recently with the timing issues. Can anyone make an informed comment? ...
by wv5k
Thu Mar 01, 2018 5:30 am
Forum: piHPSDR
Topic: New install on new Kubuntu
Replies: 2
Views: 1391

Re: New install on new Kubuntu

Hmmm, thought that's what I was doing with the git checkout and "make" for both wdsp and pihpsdr. Ok, I'll dig further.

Jim
WV5K
by wv5k
Wed Feb 28, 2018 5:11 am
Forum: piHPSDR
Topic: New install on new Kubuntu
Replies: 2
Views: 1391

New install on new Kubuntu

Evening All, Not a Linux neophyte, but not much more than a shell programmer here either. Checked out everything via git, as per the build instructions document. Cut and paste in terminal window for each step, all compiles/installs completed successfully. Problem is that when running the startup scr...
by wv5k
Fri Jul 21, 2017 3:25 pm
Forum: Digital ("Virtual") Audio
Topic: Audio input routing when VAC is active
Replies: 10
Views: 3621

Re: Audio input routing when VAC is active

Hello Scott, Yes, just as you surmise, PowerSDR just "saw" the Focusrite ASIO driver (not sure if it's 18i20 2nd Gen specific though) the first time I powered it all up, with output audio just working. Took a little bit to figure out that the MIC and preamp controls were useless going this...
by wv5k
Thu Jul 20, 2017 8:56 pm
Forum: Digital ("Virtual") Audio
Topic: Audio input routing when VAC is active
Replies: 10
Views: 3621

Re: Audio input routing when VAC is active

Yes! PTT override needed to be enabled (I *am* using a hand PTT button after all ;-)). Just goes to show how long it's been since I needed to start from bare metal with PowerSDR. I have several interfaces here, but as the shack's gear here has everything that needs a speaker routed through the 18i20...
by wv5k
Thu Jul 20, 2017 2:42 pm
Forum: Digital ("Virtual") Audio
Topic: Audio input routing when VAC is active
Replies: 10
Views: 3621

Audio input routing when VAC is active

Morning All, New Anan 200D owner. Had a Flex 5000A for nearly a decade before the Anan, so VERY familiar with Flex's version of PowerSDR. I'm feeding my 200D everything via ethernet, and VAC (through a Focusrite 18i20). Mic plugged into 18i20 (needed for phantom power). Anan sees the mic via the Foc...

Go to advanced search