Asking Apache Labs Support about the status of the current reading issue, I got this reply within a few hours: --------------------------------------------------------------- Von: support@apache-labs.com Gesendet: Dienstag, 5. April 2022 15:31 An: 'Thomas Wrede' Betreff: RE: Re: New Anan 7000DLE MKI...

Dear all,

Thanks for your comments. Apache Labs Support in the meantime gave me the following explanation:

"The old current sensor chip used previously has been obsoleted and replaced by a new one, the software will be updated shortly to support the new chip".

73,

Thomas

Mark,

Thanks - everything is properly calibrated and I am using a digital vector wattmeter. Output is 100W. I have asked Apache Labs if they made a change in the last production lot. Could be even a wrong component. Unfortunately I don't have a circuit diagram of the PA.

73, Thomas

Interesting, same here: 0A on receive and 6.6A on 80m with Tune at about 100W. My guess is that Apache Labs in the last production batch has made a change or has used a different sensor chip. I have no clue how the voltage/current readings are happening via the software. We need feedback from Apache...

Hi Leon, A screenshot with a two tone signal is attached. The power supply indicates about 12.5A total (80m). The on-screen reading is 3.6A which is too low. WIth a single tone (Tune) the Thetis display indicates 6.6A which is too low either. I probably need to contact Apache Lab's support. I do not...

Last week I received my new Anan 7000 (the one without external fan connector, just a rectangular hole.....). I operate it with Thetis 2.8.11 21k7 which allows to display the voltage/current information of the Anan PA. However, with full 100W CW output depending on the band and SWR the maximum curre...