Hallo Norbert,
Ich bin nicht sehr bewandert mit Internetkonferenzen, aber ich habe nun Skype installiert.
Eine Einladung ist aktiv: https://join.skype.com/invite/FQ9YyazHZVqx
Ansonsten, meine Telefon Nr. ist +436763666000.
73 Gerhard

Hi Scott,
Yes, I did refresh the database. The only thing is I could not produce a new fft-calculation as this wisdom file is somewhere else to delete.
Yes, I now also think it is a hardware problem.

Hi Norbert,
Will try to be online tomorrow afternoon. Have to think about the proper way.

73 Gerhard

Hi,

ADC2 = ADC1 in setup is only connected to DDC1 = RX2. RX BNC is open, or terminated with 50 Ohm or shortcut - all the same result.


73 Gerhard

Hi Scott, before I used Protocol 1 and PowerSDR mRX PS V3.4.9. I just wanted to change to P2. At the same time I also changed my Hermes from P1 to P2 and there I definitly know that I had to open the housing to set jumpers. Here at the ANAN-100D I am not sure about this any more. If it was necessary...

Hi All, Did not find an answer to my problem by searching all messages, so here my question: I am using ANAN-100D with Rev24 PA+Filter board, FW 12.1.8, Protocol 2, Thetis V2.8.11 x64 MW0LGE 21i. RX2 is disabled on TX. I do get an ADC2 overload message on TX in yellow and sometimes in red, even if I...