Upon further investigation I have found the source of the clicks etc on the audio, believe it or not, it's the action of the mouse wheel and firefox, when displaying a page where it is necessary to use the scroll wheel, like a swap shop etc, I hear the intermittent clicks and noises on the anan audi...

Thanks for the reply, I have it working now. What prompted this, was some audio clicks I could hear especially when using the NR and NR2 selections, I did look around on the forums and I noticed that a recent update to win10 may be the culprit. I also hear the intermittent clicks on the speaker as w...

Just to verify, the 1/4" l & R jacks on the rear panel cannot drive a regular unpowered speaker? I plugged speakers in (mono plug), and I get no audio out. Or is the a setting in the setup for this..thanks

Using a 7000DLE without internal pc

These pictures were supplied with the radio when I received it

Provide Pure Signal input from an external amplifier. I haven't really looked into it yet, I don't have an amp ....

Many thanks to Doug W5WC for getting me fixed up with the anan. It turns out I didn't actually brick it, what happened was the previous owner had installed a relay and switch for puresignal and an amplifier, but instead of plugging in the "normal/bootloader" switch back into j17, they plug...

How do I get in contact with Doug, W5WC for the Bootloader code and directions?

The next question is, what sort of usb blaster am I looking for? These are listed on amazon.com USB Blaster Download Cable ALTERA FPGA CPLD USB 2.0 PC JTAG AS,PS Programmer Debugger @XYGStudy Compatible XILINX Platform Cable USB FPGA CPLD JTAG SPI Download Debugger Programmer DLC9G thanks for your h...

Yes I clicked the "test for bootloader" button each time

ea3aqr wrote:Supersticious or not I was unable to discover my radio going thru my dumb switches...

A direct connection cable between the radio and the PC did the trick!

I tried the direct connection, there was no change

I confirmed that I am using the suggested version of winpcap. I tried HPSDRBootloader with both switch positions and I did it twice in each instance. Once by running the software and then turning on the anan and once by turning on the anan and then running the software. I also ran HPSDRBootloader in...

I inspected the radio as per your instructions and I see I have the EPCS chip and in fact no jumper. I was using the winpcap and not the win10pcap... but I didn't rename the rbf to metis. The switch is a netgear GS605v2.
Having said all that, whats next.

Hello, I tried to update my ANAN7000 from prot 1 to prot 2, but I am having a problem. After the failed update now the board is not found anymore.,. The LED's at the link have the left on steady and the right flashes. The two red led's on the left have the left one on steady and the right one no lon...