I wish that the AM to SSB TX profiles would change with mode as well, just like in 3.4.9 of protocol 1. This is because most of us use different TX profiles between SSB and AM. at the moment, lsb, usb, am, sam, etc are one and the same. digu/digl and fm have their own tx profile store. I will add A...

I wish that the AM to SSB TX profiles would change with mode as well, just like in 3.4.9 of protocol 1. This is because most of us use different TX profiles between SSB and AM.

I have noticed on Thetis that the transmit profile does not change on a mode change like in protocol1. I found that to be very convenient using protocol 1 because I use different TX profiles for different modes. Now with Thetis its a two step operation when I change modes. Can this be incorporated i...

I’ve noticed that PS status is now saved in the TX profile. The only problem is is when that profile is selected after using a profile without PS, you have to turn PS off and then on again to get it to work.
Frank W2SDR

All fine here!!

I did read your post Scott and I posted what I did but I guess I wasn't totally clear about what has to be done. If on a new install of Potato if you had selected a hardware input driver BEFORE you select the ASIO driver in the hardware out section you cannot get the automatic ASIO selection in the ...

I have now configured the program for my Behringer ASIO hardware input. I re-initialized Potato in the menu and then selected the UMC ASIO Driver for the output in A1. Automatically the ASIO driver was then selected for hardware input in Channel 1. The key is to select Hardware OUT first!!

I have a Behringer umc 202HD and the drivers are installed on the computer and not being used by A
Anything else.

Why isn’t ASIO selectable in the hardware input drop down?

I just wish it would stay running for more than 3 hours. I have Voicemeeter running now and I’ll see if it continues to run

I just installed Potato yesterday. A few observations: It will only run in PowerSDR at 96000. I’m usong a UMC202HD. I’m going through hardware input 1 using WDM for UMC202HD. Have radio vac1 set for 96000 and 512 buffers. Using UMC ASIO for A1 output. All ok, except that after maybe an hour or to in...

Thanks Scott, I’ll think about all my options. I’m leaning on sticking with the quite stable built in TCXO!!

How difficult is it to get to these jumpers?

Scott,
My BG7TBL is only putting out -5 dbm into the radio thru 10db att. In other words +5 dbm
Frank

Bryan,
It locks in no problem, but I have to adjust the "correction factor" in the menu to get it on freq with WWV. I ended up with a setting of
1.00000850. It stays right there once adjusted however.

BG7 TBL is the unit I am using. When connected to my 200D no calibration was needed in the menu. Now with the 7000 I have to adjust the calibration to get it aligned with WWV. Is this normal?