Hi Scott,

Thank you I will have a look at the group. About the issue I will inform.

73 Chris

Hello together, now the connection between Anan and Expert is working fine while connecting each other direct. Next step is DDUTIL. I’ve seen the presets for drive power a.s.o. and I want to play with this features. The connection between PowerSDR and DDUTIL works without trouble so I can see the ri...

Hello together, My external amp can give full output power at an input of 10 Watts. Is there a chance to reduce the output power of the Anan to 10 Watts in general, f.e. with bypassing the internal amp of the Anan? Would be interesting if there is another way than using the power slider on the GUI. ...

Hi Scott,

I was thinking too complicated. Direct connect between Anan and Expert via Com 4 works. The test via ddutil will follow.

73 Chris

Hi Scott,

Thanks a lot. Will test the direct connect and also with ddutil. You’re totally right with splitting and ddutil. Will try both ways and report it.

Maaany thanks,

Chris

Hi folks, got a problem connecting the Expert 1k3 to the Anan 200d. Wiring is like the chart. Expert cat config: Kenwood, 9k6, Input 1 Vspe: Com7 connector Com7 com 17 Splitter 9k6, Stp bit 1 Emulations on Hpsdr cat Catcontrol : Enable hacken, Port com 7 9k6 Sop bit 1 ID as power SDR Ddutil: Setup F...

Hi Scott,

reseting the midi setup did not have any impact, only at the new database, when I load the file.

73 Chris

Hi Scott,

now I have found the issue. If I load my file for the midi console then there is the bug with vac. Tested it today several times. Maybe it's for interest for the developers community.

73 Chris

Hi Scott,

Thanks a lot! Solution was to rename the PowerSDR folder and to create a complete new database. Now VAC works fine as before. Had been running VAC and PowerSDR since 2009 but never had an issue like this.

Thanks for solving & 73
Chris

Hi Scott, Thanks a lot. You're right, the relay its not. The Anan works well on my backup PC. So the hardware is fine...puhhh. On the backup I use the VAC 4.13 with the last PowerSDR release and the actual FLDigi (or wsjt, wspr a.s.o.). The main machine runs the newest release of PowerSDR with VAC 4...

Hello, Actually I have a problem concerning VAC. Have been using the sw since 2009 and never had any trouble. But today I do not get any RX output from VAC to any third party sw. I can transmit without any problems and I also can switch the cables. Every new cable pair shows the same, transmit works...